How to Measure a Site for a WPC Garden House

Measure the space your site can accommodate and the clear space you need inside. Put both on the same sketch so the factory can see which dimensions matter most.

1. Mark the available footprint

Measure the usable length and width at ground level. Draw any wall, fence or existing paving that limits where the base can sit. If the roof has to stay inside that boundary as well, mark it separately on the sketch.

2. Measure what needs to fit inside

List the largest items you plan to store. Note their width, depth and height, then mark the clear space needed to move them. The usable space inside depends on the frame and wall construction, so give the factory your clearance needs separately from the footprint.

3. Check the entrance and access path

Mark the preferred door position. Measure the widest item that will pass through and note turns, steps or walls along the route. Ask for the clear opening of the proposed door configuration.

4. Record the height limit

Measure from the proposed base level to any overhead limit. Say whether your figure describes the maximum outside height, including the roof, or the clear height you need inside.

What to put on your sketch

  • Ground-level length and width, with units.
  • The space to keep clear inside and the largest item that will use the entrance.
  • Preferred door position and any access restrictions.
  • The maximum roof height and the point you measured from.
  • Intended use and quantity. Mark approximate measurements clearly.
Scroll to Top